Le prйsent appareil est conforme а l'exposition aux radiations FCC / IC dйfinies pour un environnement non contrфlй et rйpond aux directives d'exposition de la frйquence de la FCC radiofrйquence (RF) dans le Supplйment C а OET65 et RSS 102 de la frйquence radio (RF) IC rиgles d'exposition. L'йmetteur ne doit pas ktre colocalisй ni fonctionner conjointement avec а autre antenne ou autre йmetteur. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numйrique de classe B est conforme а la norme canadienne ICES-003. 58 | P a g e FCC Class B digital device notice CAN ICES-3 (B) / NMB-3 (B) Ownerґs Manual DEA600 Radio Delphi Electronics & Safety has not approved any changes or modifications to this device by the user. Any changes or modifications could void the user’s authority to operate the equipment.
Delphi Electronics&Safety n’approuve aucune modification apportйe а l’appareil par l’utilisateur, quelle qu’en soit la nature. Tout changement ou modification peuvent annuler le droit d’utilisation de l’appareil par l’utilisateur. This device complies with Part 15 of the FCC Rules and Industry Canada licence exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le prйsent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisйe aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioйlectrique subi, mкme si le brouillage est susceptible d'en compromettre le fonctionnement. The equipment receives power supply from a specific external power supply according to 2.5 paragraph of EN 60950-1. L'йquipement reзoit l'alimentation йlectrique d'une source d'alimentation externe spйcifique selon le paragraphe 2.5 de la norme EN 60950-1.
This device complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines in Supplement C to OET65 and RSS 102 of the IC radio frequency (RF) Exposure rules. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Conformity assessment issues FCC/IC Regulatory Notice Radiation Exposure Statement Modification statement Interference statement Limited Power Sources