Komatsu — CHECK BEFORE STARTING ENGINE, ADJUST

. OPERATION OPERATION (E) Seat height adjustment FASTENING AND REMOVING SEAT BELT (If equipped) WARNING 4. Pull the belt to check that it is securely locked in position. 5. When removing the belt, press the red button on buckle (3). The belt will automatically retract. 3 - 81 Pull up levers (4) and (5) alter nately to adjust the angle of the seat. Then, release the levers to loc (Height adjustment distance: Before fastening the seat belt, check that there is no problem in the securin g brackets or belt. If t here is any wear or damage, replace. Even if there appears to be no problem in the seat belt, replace the seat bel t once every 3 years.

The date of manufacture is woven on the reverse side of t he belt. before operating the machine. operating the machine. ther half of the belt twisted. Adjust and fasten the seat belt Always use the seat belt when Do not use the seat belt with ei Check that the bolts of the cla mp securing the belt to the chassis are not loose. Tighten t The tightening torque for the mounting bolt is 24.5 ± 4.9 Nm (2.5 ± 0.5 kgm, 18.1 ± 3.6 lb If the belt surface is scratched or frayed or if the fittings are broken or deformed, replace FASTENING AND REMOVING SEA T BELT osition, adjust tether belt (1). Tense 1. After adjusting the seat p the tether belt and install i seat. 2.

Sit on the seat and hold mechanism (2) and pull o cover your abdomen suffi 3. Insert tongue (4) in buckle back into wind-in mecha abdomen. The belt is lock be extended anymore. Fi twisting it. t when there is no one sitting on the tongue (4) connected to wind-in ut the belt slowly so that the belt will ciently. (3) until it clicks. The belt is pulled nism (2) until it is fitted to your ed under this condition and cannot t the belt to your abdomen without REMARK If the belt is locked before the tongue is inserted in the buckle, let it return to the wind-in me procedure from the start. chanism, then repeat the above