. OPERATION TRANSPORTATION ground surface. REMARK 2. Remove the quick coupler (1), then remove the work equipment assembly. 3. Remove right and left trunnions (2). (D65PX,D65WX) PRECAUTIONS WHEN REMOVING ROPS mounting 1. Loosen bolts (1) and remove ROPS.
3 - 119 PRECAUTIONS WHEN REMOVING WORK EQUIPMENT If there is any pressure remaining in the tilt piping after t he wor k equipment has b een removed, it ma y be difficult to remove the quick coup ler of the tilt hose, so remove the work equipment as follo horizon the If the blade is tiled, the tilt piping will be under internal pr essure , so set the blade horizonta REMARK If the machine mod el is D65PX and D65WX, remov e right and left trunnions (2). el is D65EX, it is not necessary to remove If the machine mod right and left trunnio is less than 3.0 m.
ns (2), because the width i ncludin g them (A) If the machine mod el is D65EX with a 3-m lon g semi U blad e, it is not necessary to blade width is less t remove the work equipment, because the han 3.0 m. cause the 4. Tie the tilt hose wit h a band to prevent it from being damaged. When removing ROPS for transporting the machine, do as follows: NOTICE ROPS is an important s afety component. Be sure to tighte bolts (1) securely to the s pecified torque when installing. Tightening torque: 785 to 980 Nm (80 to 100 kgm, 578. 6 to 723.