Komatsu — LIFTING MACHINE

. OPERATION TRANSPORTATION For machine equipped with ripper When lifting the machine, stop it on a level place, then observe the following procedure. 1. Stop the engine and set the parking brake lever to the LOCK position (L) securely. 2. Set the work equipment lock lever to the LOCK position (L) securely. 3. Install wire ropes, slings, etc. matched to the weight of the machine to the lifting points as shown in the above figure. NOTICE with the machine. 3 - 124 Fit the wire ropes at the center to both left and the right p Hang the rear wire rope to ripper beam (3).

Use protectors to prevent the wire rope from being cut on sharp c and to prevent the wire rope from cutting into the machine body When using a spreader bar, select an ample width to prevent c 4. After setting the wire ropes, lift up the machine and stop at 100 to 200 mm (3.9 to 7.9 in) abo ve the ground , and check that the wire ropes are not slack and the machine is level, then lift up slowly.