. MAINTENANCE GUIDE TO MAINTENANCE Before opening the cab door, always close the engine side cover. If the lock for the engine side cover is not released, it will not close. If any attempt is made to close it without releasing the lock, the gas damper may break. the gas damper (1) to release the lock, then close the cover. 4 - 3 DUSTY WORKSITES: worksites, do as follows: ator frequently to see if the air cleaner is dirty or clogged. re frequently to avoid clogging. e fuel filter frequently. onents, especially the starting motor and alternator, to avoid accumulation of dust.
When working at dusty Inspect the dust indic ator frequently to see if the air c Clean the radiator co Clean and replace th Clean electrical comp onents, especially the starting motor and alternator, to avoid accu When inspecting or c hanging the oil, move the machi ne to a place that is free of dust to prevent dirt from getting into the oil. AVOID MIXING OILS: If a different brand or gra de of oil has to be added, drain t he old oil and replace all the oil wit h the new brand or grade of oil. Never mix differe nt brand or grade of oil. PRECAUTIONS FOR OPENING AND CLOSING ENGINE SIDE COVER: Open the engine side cover all the way and ensure that it is locked open before letting go.
When standing on the track to open the engine side cover, bend at the knees and open the cover in a standing position to avoid back strain. er, push the orange button in th LOCKING THE INSPECT ION COVER: securely into position with the lock bar. If inspection or maintenance is performed with Lock inspection cover inspection cover not loc ked in position, there is a dange r that it may be suddenly blow shu t by the wind and cause injury to the worker. HYDRAULIC SYSTEM-AI R BLEEDING: After repairing or replac ing hydraulic equipment or after removing the hydraulic piping, it is necessary to bleed the air from the circuit.
For details, see "PROCEDURE FOR BLEEDING AIR IN HYDRAULIC SYSTEM (PAGE 4-41)".