. MAINTENANCE SERVICE PROCEDURE REVERSE AND REPLACE END BITS AND CUTTING EDGES WARNING The symbols in the work equipment column have the following meaning. A: Powertilt dozer (D65EX) B: Powertilt dozer (D65PX) C: Powertilt, Power pitch dozer (D65PX) D: Semi-U blade (3m)(D65EX) E: Semi-U blade (D65EX) F: Semi-U blade (D65WX) G: Angledozer (D65EX) H: Angledozer (D65PX) REMARK If the cutting edge and the end bit on both sides are worn out, replace with new ones. If it has been worn out up to the fitting surface, repair the fitting surface and then reverse or replace.
4 - 29 It is d angerous if t he work equipmen t moves during t he tu rning or replacement o peration Set t he w ork equipment in a stable c ondition, set the work equipment lock l ever t o the LOCK p osition, t hen stop the e Revers e or replace the end b its and cutting edges b efor e it is worn out to the blade e nd. 1. Rai se the blade to a proper height, p osition a bl ock u nder the fr ame t o prevent th e blade from falling. 2. Set the work equipment l ock lever to the LOCK position and st op the engine. 3. Measure the wear o f the end bit and cutting edge in accordanc e with the wear st andard s given below Wear st andards Item Judgement criteria (mm) No.
Dimension to be measured Work equipment Basic dimension Allowable max. value 1 Height of end bit (outside) A,G 242 187 B,C 204 187 D 292 237 E,F 315 237 H 222 204 2 Width of end bit A,B,C 325 300 D 435 410 E,F 540 515 G,H 325 310 3 Height of end bit (inside) A,B,C,G 204 187 D,E,F 254 237 H 222 204 4 Height of cutting edge (Center of bolt mounting hole to edge) A to H 102 85