Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE 4 - 41 PROCEDURE FOR BLEEDING AIR IN HYDRAULIC SY See "STARTING ENGINE Since the engine must be s tarted and the blade mus t be oper ated, see O PERATION. NOTICE If the engine is run at high spee d immediately after startup o r a cylinder is pushed up to its stroke e nd, air take n inside the cylinder may cause damage to the pist 1. Bleed air from left pitch (Powertilt, Power pitch Bleeding air from the h making the repairs. 1) Start the engine an d run it at low idle for at a bout 5 mi 2) Raise the blade.

3) Bleeding air in the t ilt hydraulic circuit by repeating left and right tilt operation fiv e to ten 4) Bleeding air from th e bottom of left cylinder by operati to pitch forward and backw ard 5 to 10 times repeatedly. 5) Set the left and righ t cylinders at the neutral position, t hen carry ou t the followi ng operations 5 t o 10 times to bleed the air from the head end of the left pitch cylin d when r emoving and installing th quipme nt or when (1) Forward pitch → (2) Left tilt → (3) Right ti lt → (4) B ackward pitc 2.

Bleeding air from cylind 1) Run the engine at l ow idle, and extend and r etract eac h cylinder 4 to 5 times, t aking car e that a cylinder is not moved to the e nd of its stroke. (Stop the cylinder a pprox. 100 mm (3.9 in) s hort of it s stroke end) 2) Next, operate each cylinder 3 to 4 times to th e end of i ts stroke. 3) Finally, operate eac h cylinder 4 to 5 times to the end o f its stroke t o completely remove the air.