. MAINTENANCE SERVICE PROCEDURE pressure of has gone down. Please contact your Komatsu METHOD OF RELEASING PRESSURE IN HYDRAULIC CIRCUIT NOTICE pressure from the circuit, control lever to the to each (A) (B) (C) (D) (E) RAISE LOWER FLOAT LEFT TILT RIGHT TILT 4 - 78 In owing case distributor Work e quipment d oes no t go d Stops while going he accumulato Finish the steps o f operating th e blade contr ol leve r to the front and back, and to th e right and left, to eac h stroke end with in 15 seconds af ter the engin e has st opped. After t he engine stops, pressure inside the accumulato r begins to gradually go dow n, so the pressu re cannot be released excep t right after the engine stops.
1. Lowe r the w ork e quipme nt an d stop the e ngine. 2. Turn t he starting switch t o the ON p ositio 3. Set th e wor k equipment lock l ever to the FREE position. 4. Opera te the blad e contro l leve r fully to the front, rear, left , and right t o release th e pressure fr om th e hydraulic circuit eleas opera te the stroke end. hydrauli ght an left 5. Set th e wor k equipment lock l ever to the LOCK position.