Komatsu — OPERATION

. ATTACHMENTS, OPTIONS HANDLING HYDRAULIC RIPPER OPERATION CHECK BEFORE STARTING ENGINE, ADJUST WALK-AROUND CHECK ADJUSTING POSTURE OF WORK EQUIPMENT 6 - 6 1. Check for wear of the p oint at t he tip o f the shank, ch eck the mounting condition, and c heck for damage to the rivets. If a ny problem is found, replace or repai PRECAUTIONS WHEN OPERATING Travel in lo w speed and lower t he rippe digging de pth is reached , move the con trol lever to the HOLD position. Do not dig the shank in d eep when star ting digging op erations During rip ping operation s, neve r turn t he machine su ddenly or travel in suddenly o r traveling in r everse , raise t he shank from t he ground surface.

When carr diggi the shanks. When start ing to travel up a stee p slope or when r eachin g the bottom o f the slope , the poin t may touch the gr ound. On hard gr ound, there is danger of the p oint breaking if it touches the ground, so raise the shank to the maximum height. ADJUSTMENT OF DIGGING DEPTH There are mo unting holes f or the p in in the shank. Select the mounting hole to match the d igging depth. Pin hole position Use Max. diggin depth W (A) d hen there is special need to ig deeply 595mm (23.4 (B) N ormal 485mm (21.9 (C) W hen not using ripper -