. ATTACHMENTS, OPTIONS AIR SUSPENSION SEAT adjustment. If your back is not pressing against the NOTICE (H) Adjusting headrest height Move the headrest up or down and set to the desired height. Amount of adjustment: 100 mm (3.9 in) Adjust the backrest to the desired curve. 6 - 22 After the automatic weig ht adjustment is carried out, the seat h eight is at the lowe st point in t he adjustmen t range. Adjust the seat to the ap propriate height. ent ent uses an air system, and it can be adjusted steplessly.
(D) Seat height adjustm The seat height adjustm ent uses an air system, and it can be a djusted steplessly When adjusting the heig ht, pull lever (3) up fully or push it dow n fully (when pullin g it up, pull it until a click is felt). When the seat is set at t he desired height, release the lever. If the lever is kept p ulled u p, th e position w here the seat does not rise any fu rther is the maximum height. When the seat reaches the maximum h eight, the sus pension automatically goes down slightly to secure the amount of move ment of the lever. t below the adjustment range. To prevent the suspensi on from reaching the bottom, do not se t to the seat heigh t below the adjustment r ange.
(E) Fore-and-aft adjustm ent of seat cushion Operate lever (4) up, set the seat cushion to the desired positio n, then release th e lever. Fore-and-aft adjustment : 60 mm (2.4 in) (F) Adjusting reclining a ngle ove the backrest to the front or rear. Move lever (5) up and m Push your back against the backrest when carrying out this ad ay suddenly spring forward. (over 20 degrees is free) backrest, the backrest m Amount of adjustment Forward tilt: 20 degrees Rear tilt: 60 degrees REMARK The seat can be reclined more when the seat is pushed to the fr ont. The amount o f reclining d ecreases as the seat is pushed back, so whe n moving the seat back, return the seat back to the uprigh t position.
If the seat back is reclined t oo far, the seat back may hit the rear glass, s o use it in a position where i t doe s not contact t he glass. (G) Adjusting headrest a ngle Rotate the backrest to th e front or rear and set to the desired a Amount of adjustment: 3 8 degrees (I) Lumbar support Operate switch (6) to giv e a suitable tension to the lumbar regi When + is pressed: Ten sion becomes stronger ion becomes weaker When - is pressed: Tens