. OPERATION EXPLANATION OF COMPONENTS FAN ROTATION SELECTOR SWITCH This switch (6) is used to switch the direction of rotation of the cooling fan. When it is released from the CLE position, it will automatically return to the Q position. Q position : Normal rotation Use this switch normally with the fan operation condition of the fan operation confirmation lamp, see "FAN OPERATION condition of the cooling fan "COOLING FAN REVERSE 3 - 22 confirmation lamp Cooling air is blow mask. The fan turns in cooling water tem cooling of the engi n out to the front from the radiator RPM commensurate with the perature, thus assuring effective ne. hen the cooling fan reverse pilot CLN position:
Cleaning Use this switch w lamp is lighted up. The fan will rotate i and will rotate at hi temperature. Use this position w n the opposite direction to normal gh speed, regardless of the water hen cleaning the radiator fins. Fo r details of the "ON" or "OF CONFIRMATION LAMP (PAGE Fo r details of the "ON" or "OFF" ROTATION PILOT LAMP (PAGE pilot lamp, see REMARK When the engine is running, even if the fan rotation selector switch is operated, the direct change. The fan operation confirmat operator that the direction of switched.
The cooling fan reverse pilot ion of rotation of the fan will not ion lamp flashes to inform the rotation of the fan has not been lamp lights up and if the fan is is already rotating in the reverse direction, to protect the radiator, even if the steering, forward-re verse,gear shift lever is operated to the FORWARD or REVER SE position, the machine will not move. Turn the starting switch OFF, then turn it again to the ON position. Operate the swi confirmation lamp is out. tch when the fan operation If the cooling fan is rotating du ring the cleaning operation, even if the starting switch is turned OFF, the power is not turned off immediately. This is to protec t the hydraulic circuits.