puls — Puls 1106 Series Marine Propulsion Engines User's Handbook

N40469 Chapter 5 • Bent pushrods • Broken socket on the upper end of a pushrod • Loose adjustment screw for the valve lash If the camshaft and valve lifters show rapid wear, look for fuel in the lubrication oil or dirty lubrication oil as a possible cause. • Valve Lash Check Corrosion This can occur when two different metals are in contact near to, or in, sea water. For example, a brass or bronze pipe fitted into aluminium can cause rapid corrosion. For this reason, special precautions are necessary when an engine is installed. In this situation, some components will be connected to a sacrificial anode fitted to the hull.

Specialist manufacturers will advise on the maintenance of these anodes. Supplementary tools A general tool kit and an on-board repair kit are available from your Perkins Distributor. It is recommended that the tools and other parts, listed below, are also retained on-board: Wire, 20 SWG (1mm in diameter) Insulation tape Jointing compound Magnet (keep this away from the compass) Mechanical fingers Self-gripping wrench Suitable lagging material Rubber olives for the low-pressure fuel system Extra blades for a small hacksaw Page 45