175 175 MOTOR SHIFT/DIFF LOCK HYDRAULICS HYDROSTATIC ENDS WITH S/N 5X0464 REF PART NO. NUMBER QTY DESCRIPTION REMARKS 1. 157-246 1 MANIFOLD (2-SP) SEE FOOTNOTE 2 214-491 COIL, 12V _ 499-446 — SOLENOID (3 WAY-2 POS VALVE) 2, 306-885 2 MOUNT PLATE SEE FOOTNOTE 3 3. 106-385 2 FLG LOCKNUT (M6-1.00) 4, 106-566 2 SCREW (M6-1.00 X 70mm) 5, 154-252 1 CONNECTOR (04S-04090) 6. 515-249 1 HOSE (040FX-26"-3000) _7. 154-316 2 RUN TEE (04S-040-040) = ~=~————SODdIFF. LOCK B. 515-711 1 HOSE (O60FX-25”-3000) 9. 154-743 1 HOSE (040FX90-23"-3000) 10. 154-220 1 CONNECTOR (040-065) 11. 515-174 1 HOSE (040FX90-74"-3000) 12, 117-611 2 ABRASION SLEEVE (1.00” X 22”) 13.
154-726 1 HOSE (O40FX90-15"-3000) 14, 154-230 1 BRANCH TEE (06S-040-040) 15. 154-226 1 CONNECTOR (040-06$90) 16. 105-003 1 FLG LOCKNUT (5/16-NC) — ~—COSSEEL FOOTNOTE1 17. 110-333 1 BOLT-ON CLAMP (1") SEE FOOTNOTE 1 1B. 154-296 1 CAP (040F) 19, 154-411 1 CONNECTOR (04S-060) 20. 154-344 2 UN RUN TEE (060FX-060-060) 21. 153-917 1 TEE (08N-060-060) o oe ess—stsi‘“SsSS oe o oe oe o FOOTNOTES| 1. #105-003 & #110-333 ATTACH TO STUD BOLTS ON FRAME PLATE. 2. EARLY PRODUCTION MANIFOLDS HAVE A CAVITY PLUG WHERE THE RELIEF VALVE WAS LOCATED. 3. WHEN “FRAME TILT” OPTION IS USED TWO MOUNT PLATES (306-885) IS REQUIRED, ONE ON EITHER SIDE OF FRAME.
WITH NO FRAME TILT ONLY ONE MOUNT PLATE (306-885) 1S USED ON OUTSIDE OF FRAME. NOTE REFER TO O-RING CHART (800-301) IN BACK OF THE BOOK FOR REPLACEMENT OF O-RINGS. 806-234