PACCAR 520 — Using a Winterfront

DRIVING - Engine Operations Cruise Control on page 101 Cancelling and Resuming Cruise Control on page 102 How to Change Cruise Set Speed on page 102 Engine Operations comply may result in death or personal in- jury. Stationary Power Take Off Operation CAUTION Do not operate the engine fan in the MAN- UAL position for extended periods of time. The fan hub was designed for intermittent operation. Sustained operation will shorten the fan hub’s service life as well as reduce fuel economy. The cruise control buttons for this vehicle may be used to control the engine rpm when the vehicle is stationary and the operator wants to use the Power Take Off (PTO) on the engine.

Use the cruise control options in the same manner as with the vehicle in motion, but instead of setting vehicle speed, the engine speed (rpm) is set instead. Important guidelines to using the engine fan control. Engine Fan Control 4 The engine fan switch on the dash has a manual and an automatic mode. In the manual mode, the engine fan will engage until the switch is back into automatic mode. In automatic mode, the engine fan operation is controlled by the engine computer. CAUTION 1. Ensure parking brakes are applied. 2. Ensure transmission is in Neutral. 3. Engage PTO per the manufacturer's operating instructions. 4. Move the ON/OFF switch to the ON position. 5.

Toggle the SET/RESUME switch to obtain the desired engine rpm. The fan or equipment near it could be dam- aged if the fan turns on suddenly when you do not expect it. Keep all tools and equip- ment away from the fan. WARNING! Using a Winterfront Do not work on or near the fan with the en- gine running. Anyone near the engine fan when it turns on could be injured. If it is set at MANUAL, the fan will turn on any time the ignition key switch is turned to the ON posi- tion. In AUTO, it could engage suddenly without warning. Before turning on the igni- tion or switching from AUTO to MANUAL, be sure no workers are near the fan.

Failure to A winterfront or other air flow restriction device may be mounted in front of the Cancel the PTO operation by canceling the engine rpm set speed. This can be done by tapping the brake or clutch pedal or by using the cruise control switches. See Also 100 Y53-6096-1A1 (01/17)