PACCAR 520 — Retarders

DRIVING - Brakes deviation between expected and actual yaw rates. Gusty winds are strong enough to cause significant side forces on the vehicle and any towed vehicles. ESC system must be disabled immediately by a qualified mechanic. WARNING! WARNING! If the Steering Angle Sensor is not recali- brated, the Yaw Control system will not function properly. A uncalibrated sensor could result in a loss of control of your vehi- cle which can lead to an accident involving death or personal injury. To maximize the effectiveness of ESC:

Failure to disable ESC "Electronic Stability Control" when modifying a vehicle could re- sult in a loss of vehicle control possibly re- sulting in an accident involving death or per- sonal injury. Loads must be properly secured and evenly distributed at all times. Drivers need to exercise extreme caution at all times, and avoid sharp turns, sudden steering inputs or abrupt lane changes at high speeds, particularly if: Retarders 4 WARNING! Ideally, you should always slow your vehicle with your retarder (where permitted by law) and use your service brakes only for stopping completely. Operating this way will greatly prolong the life of your brakes.

For vehicles equipped with ESC" Electronic Stability Control" do not replace the vehi- cle’s steering wheel with an aftermarket or different part number than originally sup- plied. Using a different steering wheel could cause ESC to malfunction causing a loss of vehicle control possibly resulting in an acci- dent involving death or personal injury. The vehicle hauls loads that could shift, The vehicle or load has a high or off-set center of gravity (CG) when loaded, or The vehicle tows doubles or triples. Various retarders are available, which function against the engine, driveline, or transmission. These are devices that use your engine’s power to slow down your vehicle.

They save wear and tear on your service brakes and can be a safety feature, too, because they can keep your brakes from overheating. The ESC system was specifically calibrated and validated only for your vehicle’s original factory-built configuration.

If your vehicle’s chassis components are altered (for example; a wheelbase extension or reduction, tag axle addition or removal, tractor to truck conversion or steering system component change) the Whenever maintenance or repair work is performed to the steering mechanism, linkage, gear, adjustment of the wheel track, or if the steering angle sensor is replaced or the steering wheel is changed or re-centered, the Steering Angle Sensor must be re-calibrated. Y53-6096-1A1 (01/17) 113