MAINTENANCE - Maintenance Schedule 5 Y53-6096-1A1 (01/17) 149 System Component Task I A B C D E Electrical and Lights Headlamps Check the aim and adjust as required. • Warning Lights in Light Bar Check at the ignition start position to verify bulbs and driver information display function. • Turn, Stop, Reverse Lights and Signals Visual check. • Alternator Check operation and output. • Check tightness of the pulley nut. • Check the tension of the drive belt; see Install Engine Belt on page 188. • Check tightness of the terminal hex nuts. • Starter Check torque on hex nuts. • ECM Connector Check the tightness of the ECM connector.
• Wheel Sensors Check for damaged sensors and connectors, and worn or frayed wires. • Fuel and Diesel Exhaust Fluid Tank Sending Unit Check the mounting screws and electrical connections for worn or damaged wires and connectors. • • Power Supply Harnesses (engine, Transmission, etc.) Check for worn or damaged insulation, corroded terminals, frayed wires, and oil or fluid leaks on the connectors or wiring. • Check for worn or damaged insulation, corroded terminals, frayed. Wash to remove excess grease. •