MAINTENANCE - Brake System 3. Looking from the ground up at the bottom of the caliper and rotor, compare the relative position of two notches; one located on the caliper and the other on the carrier. 4. Take a measurement from between these two notches and compare them to the specifications to determine if the pads need to be replaced. 3. Temporarily release the parking brakes. 4. Grab the caliper and move it. This movement is Running Clearance. 5. Proper Running Clearance is 0.08 inch (2 mm) of movement of the brake caliper (approximately the thickness of a nickel) in the inboard/ outboard direction.
Have a qualified mechanic provide further inspection if the caliper does not move or appears to move more than the specified clearance 5 Have a qualified mechanic perform a detailed inspection if the notches are not found. The pads and rotors should be measured and compared against the manufacturers specifications located in the brake manufacturer’s service manual. 1. Retracted Position, no brake pedal applied 2. Applied Position, brake pedal engaged The autoslack adjuster is a mechanism to maintain the correct amount of space between the braking surface and the friction material.
Auto Slack Adjuster Inspect Disc Brake Caliper for Running Clearance Drum Brake Inspection Running clearance describes the amount of movement between the caliper and the mounting flange. Important information about checking the brakes. Have brake drum linings inspected by a qualified mechanic for wear at regular intervals according to the maintenance schedule. In severe service or off-highway applications inspect the linings more frequently. In addition, periodically check the brake chamber stroke. Replace the Regularly inspect caliper for Running Clearance: 1. Stop the vehicle on level ground and let the brakes cool down. Hot brake calipers can burn skin on contact. 2. Chock the wheels.
162 Y53-6096-1A1 (01/17)