MAINTENANCE - Electrical System Removing Batteries Installing Batteries 2. Reconnect positive cable. 3. Reconnect ground (negative) ground cable. Information on removing batteries. Follow the procedure below to reinstall main batteries on the vehicle: After accessing the battery, these steps can be used to remove them from the vehicle. Slow Battery Charging NOTE A slow trickle charge is recommended for optimum performance from the batteries. 1. Be sure all switches on the vehicle are turned OFF. 2. Wait 2 minutes after turning ignition off then disconnect negative ground cable first. 3. Disconnect positive cable. 4. Unscrew the holding plate bolts with open end wrench.
Always dispose of automotive batteries in a safe and responsible manner. Contact your authorized dealer for disposal standards. Call your local authorized recycling center for information on recycling automotive bat- teries. WARNING! Charger cables must be connected positive to positive (+ to +) and negative to negative ( - to - ). If connected improperly, batteries could explode. Failure to comply may result in death, personal injury, equipment or prop- erty damage. 5 NOTE Make sure to reconnect the ground (nega- tive) cable last. NOTE WARNING! Always dispose of automotive bat- teries in a safe and responsible manner. Contact your authorized dealer for disposal standards.
Call your local authorized recycling cen- ter for information on recycling auto- motive batteries. WARNING! Always make sure the battery charger is OFF before connecting or disconnecting the cable clamps. To reduce the danger of ex- plosions and resulting death or personal in- jury, do not connect or disconnect charger cables while the charger is operating. Battery replacement may alter or disturb battery cable routing. Check to insure bat- tery cables are free from any point of chaff- ing. Failure to comply may result in death, personal injury, equipment or property dam- age. Follow the procedures below to reinstall batteries on the vehicle and replace parts removed for access. 1.
Place batteries in vehicle and tighten bolt of holding plate. Y53-6096-1A1 (01/17) 185