PACCAR 520 — Frame

MAINTENANCE - Fuel System Check for complete insertion of motor mount. Replace as necessary. New leg to mount flange head bolts should be torqued to 210-230 lb-ft (284-311 Nm). Use only the fuel and/or additives recom- mended for your engine. Failure to comply may result in death, personal injury, equip- ment or property damage. comply may result in death, personal injury, equipment or property damage. WARNING! CAUTION Frame welding is NOT recommended. The high heat of welding nullifies the special heat treatment of the rails, greatly reducing the tensile strength of the frame rail.

If a frame member becomes cracked from over- loading, fatigue, surface damage or a colli- sion, the only permanent repair is to replace the damaged frame member with a new part. Fuel System If anyone ever pours gasoline into your fuel tank, drain the entire system. Otherwise, the pump and engine will be damaged. Don’t try to dilute the gasoline by adding diesel fuel (See Warning above). 5 Important information on your vehicle's fuel system. Location of Fuel Shut-off Valves Fuel Filters Fuel shut-off valves for the fuel crossover line are on the bottom of the secondary fuel tank, at the crossover line connection. They are optional on the primary fuel tank.

See Engine Manufacturer’s Operator Manual provided with this chassis. In an emergency, a temporary repair may be performed. Observe the following precautions to protect electronic systems during welding operations. Emergency welding procedures are further explained in the maintenance manuals. Please refer to the ordering information on the back cover to obtain a maintenance manual. Emergency Welding Frame Use only diesel fuel as recommended by engine manufacturers. Specification WARNING! WARNING! Diesel fuel in the presence of an ignition source could cause an explosion. A mixture of gasoline or alcohol with diesel fuel in- creases this risk of explosion.

Do not re- move a fuel tank cap near an open flame. Do not cut, splice or weld frame rails or drill through the top or bottom flanges of the rails. These operations could affect frame rail strength leading to a failure resulting in an accident. Rail failures resulting from such modifications are not warrantable. Failure to In the event of emergency welding of a frame rail and when welding any other part of your truck or any component attached to your truck, observe the following precautions before welding: 192 Y53-6096-1A1 (01/17)