PACCAR 520 — Front Axle and Suspension

MAINTENANCE - Front Axle and Suspension side of the fifth wheel plate. Use a water resistant lithium-base grease. Kingpin Lubrication Suspension Lubrication NOTE The plate must be lifted up slightly to relieve the weight of the bracket while applying grease. Front Axle and Suspension Each standard spring anchor pin has a grease fitting. Pressure lubricate spring pins as specified. At regular intervals, the spring leaves may be lubricated with a rust-inhibiting oil applied with a spray gun or brush. Depending on your suspension, lubricate all spring pins until grease flows out of both ends of the bushing. Look for signs of rust or water in the flushed grease.

If a pin will not accept grease, it should be removed, cleaned, and inspected. 5 Lubrication and inspection of front axle assemblies. Refer to the axle manufacturer's operator's manual for lubrication specifications and service intervals. Axle Lubrication Lubricate with approved lubricant. Lubricate knuckle thrust bearings, knuckle pins, and tie rod ends. Lack of lubrication causes premature wear and hard steering. Lubrication schedule may be shortened if necessary. CAUTION Do not spray the suspension with chemical products or mineral oil; it can cause damage to the bushings. 194 Y53-6096-1A1 (01/17)