EMERGENCY - Roadside Assistance this time. If it has not, stop the engine and let it cool before checking to see if the coolant is low. 7. Be sure the vehicle is parked on level ground or the readings may be incorrect. Check the coolant level at the cooling module surge tank. CAUTION WARNING! If the truck is equipped with power take off (PTO) equipment, the en- gine shutdown system can be deac- tivated when the PTO is operational; however, engine idle periods should not exceed five minutes whenever possible. Failure to comply may re- sult in equipment or property dam- age. Do not replace a fuse with a fuse of a higher rating. Doing so may damage the electrical system and cause a fire.
Failure to comply may result in death, personal injury, equip- ment or property damage. 2 Check the coolant level after each trip when the engine has cooled. The coolant level should be visible within the surge tank —add coolant if necessary. CAUTION 2. Check to ensure the Oil Pressure Gauge reads normal. 3. Make sure the engine fan is turning by switching the Engine Fan Switch from AUTO to MAN (Manual). 4. Increase the engine speed to about one-half of full operating speed, or 1,100 to 1,200 rpm, maximum for 2 or 3 minutes. 5. Return the engine speed to normal idle. Monitor the engine temperature.
After the temperature returns to normal, allow the engine to idle 3 to 5 minutes before shutting it off. This allows the engine to cool gradually and uniformly. 6. If overheating came from severe operating conditions, the temperature should have cooled by See Also Engine - Coolant Temperature on page 66 Engine, Low Coolant Level on page 62 Engine, Coolant Temperature on page 62 Inspect Coolant Level on page 172 Never patch fuses with tin foil or wire. This may cause serious damage elsewhere in the electrical circuit, and it may cause a fire.
CAUTION If a circuit keeps blowing fuses, have the electrical system inspected for a short circuit or overload by an authorized dealer as soon as possible. Failure to do so could cause serious damage to the electrical system and/or vehicle. How to inspect and replace a fuse All the electrical circuits have fuses to protect them from a short circuit or overload. If something electrical on your chassis stops working, the first thing you should check for is a blown fuse. Turn the ignition off and turn all lights off. Locate the fuses in either the cab, sleeper or main power fuse box. Y53-6096-1A1 (01/17) 33