PACCAR 520 — Returning to Service After Recovering

EMERGENCY - How to Recover a Vehicle What are the Best Practices for Recovery Rigging? 1. Into the pinion cage, add 1 pint (.47 liter) of lubricant or into the interaxle differential, add 2 pints (.94 liter) of approved lubricant. 2. After adding the specified type and amount of lubricant, drive the vehicle. It should be unloaded. Drive 1 to 2 miles (1.5 to 3 km) at a speed lower than 25 mph (40 km/h). This will thoroughly circulate the lubricant through the assembly. 3. If the parking brakes were manually released, they will need to be modified back to their normal operating condition. 4.

If the differential lock was manually locked, then the caging bolt needs to be put back in its storage location and the differential lock air line needs to be re-installed in its normal position. Use these guidelines when recovering a vehicle with rigging and hitches. 2 CAUTION Recovery pull maximums assume the tow rigging evenly distributes the load between both recovery hitches. See examples in Re- covery Rigging for details. Serious damage to the vehicle may occur if rigging is not connected properly. Use a double chain or cable setup that distributes the load equally to both hitches. See 1 or 2 in Recovery Rigging illustration.

CAUTION Never loop a single chain or cable through both hitches (3). When recovering ditched or bogged vehi- cles, stay well below Maximum Capacities. Even at loads below maximum, the physical strain of recovering a vehicle could damage axles, suspensions, fifth wheels, etc. Use a spreader or equalizer bar to distribute the load on both hitches (1). If no spreader bar is available, connect the main tow chain or cable no closer than 6 ft. from the vehicle (2). Add lubricant back to the axles after recovering the vehicle and before putting it back in to service.

Returning to Service After Recovering Once the vehicle is recovered, the axles need to have oil added to prevent gear damage during operation. Y53-6096-1A1 (01/17) 45