CONTROLS - How to Manually Control the Air Conditioner for the Cab 5. Select the recirculation button for FRESH or RECIRC air. How to Manually Control the Air Conditioner for the Cab NOTE Fan Control Dial must also be in the ON po- sition for A/C to be on. A/C engages auto- matically in AUTO, defrost and floor/defrost. The temperature of the air from the vents will fluctuate as the vehicle works to achieve the chosen cab temperature. 3 When idling for short periods of time, keep the fan ON and set the air mode to FRESH air. For vehicles with a sleeper, the cab control can be used to activate/deactivate the sleeper HVAC using the button inside the mode dial.
Information on controls to set cab heating and air conditioning. The air conditioner defaults to Manual mode when turned on. The fan speed, air temperature, and air outlets are selected using the dials on the controller. Temperature Control Set Point The cab temperature is set using the temperature control dial. The operating range is 60°F (16°C) and 84°F (28°C). Adjustments of 2° increments. 1. To adjust the fan speed, turn the fan control dial clockwise to increase speed or counterclockwise to decrease speed. Setting the fan dial to "O" turns the HVAC system off. 2. To adjust the temperature setting, turn the temperature control dial to the desired temperature.
The system automatically adjusts the outlet air temperature to achieve the desired cab temperature. 3. Push the snowflake button if the air temperature needs to be colder, this button will manually turn on the compressor. 4. To adjust the air distribution, turn the air distribution dial to the desired position as indicated by the graphics. Dash Switches This custom vehicle will have a wide variety of switch controlled equipment. However, this particular vehicle may not have every switch identified in this section of the operator manual.
Some air device switches on the dash may require that the vehicle either be at a specific speed, park brakes set or another device to be on or off for the air device to operate. The instrument display will display information regarding what needs to change in order for the air device to operate as expected. The following table provides a complete list of icons that may be found on the switch. Air Conditioner Button The button inside the temperature control dial engages the A/C compressor. When activated the indicator on the button will illuminate. During AUTO mode, the A/C button indicator will remain illuminated at all times even though the compressor may be cycling. 80 Y53-6096-1A1 (01/17)