Engine Storage WARNING: EYE INJURY To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. 6. Clean the exterior of the engine (except electrical parts) with fuel oil and dry with compressed air. 7. Seal all engine openings. The material used must be waterproof, vapor-proof and possess sufficient physical strength to resist puncture and damage from the expansion of entrapped air. Extended Storage (More than 30 Days) Outdoor storage of the engine is not recommended. If units must be kept out of doors, follow the preparation and storage instructions already given.
Protect units with quality, weather-resistant tarpaulins (or other suitable covers) arranged to provide for air circulation. NOTICE: Do not use plastic sheeting for outdoor storage. Enough moisture can condense on the inside of the plastic to rust ferrous metal surfaces and pit aluminum surfaces. If a unit is stored outside for any extended period of time, severe corrosion damage can result. NOTE: Plastic is fine for indoor storage. The stored engine should be inspected periodically. If there are any indications of rust or corrosion, corrective steps must be taken to prevent damage to the engine parts.
Perform a complete inspection at the end of one year and apply additional treatment as required. To prepare an engine for extended storage (more than 30 days), follow this procedure: 1. Drain the cooling system. Refer to section "Cooling System Drain Procedure", and flush with clean, soft water. Refill with clean, soft water and add a rust inhibitor to the cooling system. 2. Circulate the coolant by operating the engine until normal operating temperature is reached. Refer to section "Cooling System Fill Procedure". 3. Stop the engine. 4. With the engine at ambient temperature and cool to the touch, drain the engine crankcase oil into a suitable container. Remove the oil filters.
Dispose of the oil and filters in an environmentally friendly manner, according to state and/or federal (EPA) recommendations. Replace the drain plug and torque to 45-50 N·m (33-77 lb·ft). 108 All information subject to change without notice. Copyright © 2014 DETROIT DIESEL CORPORATION DDC-SVC-MAN-0175