Operating Instructions for Starting the Engine WARNING: HOT OIL To avoid injury from hot oil, do not operate the engine with the rocker cover(s) removed. 1. Observe the oil pressure gauge immediately after starting the engine. An oil pressure gauge that registers pressure 14 psi (96 kPa) at idle speed and normal operating temperature is a good indicator that all moving parts are getting lubrication. 2. If no pressure is indicated within 10 to 15 seconds, stop the engine and check the lubrication system at normal operating temperature. 3. The oil pressure should not drop below 55 psi (380 kPa) at 1800 rpm, at normal operating temperature.
If oil pressure does not fall within these guidelines, check it with a manual gauge. Warming Up the Engine Run the engine at part throttle for about five minutes to allow it to warm up before applying a load. Inspection During Idling While the engine is idling, inspect the transmission and crankcase for fluid leaks. On DD15 engines, check the Axial Power Turbine (APT) for oil leaks. Checking the Transmission While the engine is idling, check the automatic transmission (if equipped) for proper oil level and add oil as required. Checking for Fluid Leaks Check for fluid leaks as follows: 1. Look for coolant, fuel, or lubricating oil leaks. 2.
If any leaks are found, shut down the engine immediately and have the leaks repaired after the engine has cooled. Checking the Crankcase Check the crankcase as follows: 1. If the engine oil was replaced, stop the engine after normal operating temperature has been reached. Allow the oil to drain back into the crankcase for about 60 minutes, then check the oil level. 28 All information subject to change without notice. Copyright © 2014 DETROIT DIESEL CORPORATION DDC-SVC-MAN-0175