MAN — Monitoring the Engine Operation

Operating Instructions for Starting the Engine WARNING: HOT COOLANT To avoid scalding from the expulsion of hot coolant, never remove the cooling system pressure cap while the engine is at operating temperature. Wear adequate protective clothing (face shield, rubber gloves, apron, and boots). Remove the cap slowly to relieve pressure. 3. Add more coolant if necessary. Open the heater valves before adding coolant. 4. Do not close the heater valves until the engine has been running briefly and the coolant level is again checked and corrected as necessary. Monitoring the Engine Operation While the engine is operating, monitor the battery charge indicator light and the oil pressure.

Excessive idling should be avoided. Monitoring the Battery Charging System The battery charge indicator light must go out once the engine starts. If the indicator light comes on while the engine is running, do the following: 1. Shut down the engine. 2. Test the charging system, per OEM guidelines. WARNING: BATTERY EXPLOSION To avoid injury from battery explosion when jump starting the engine, do not attach the cable end to the negative terminal of the disabled battery. 3. If necessary, visit the nearest authorized dealer to have the alternator voltage and output checked. 4. Do a load test on the batteries. 5. Replace components as needed.

Monitoring the Oil Pressure When the engine has reached its normal operating temperature, the engine oil pressure must not drop below the following values: 55 psi (380 kPa) at rated speed 14 psi (97 kPa) at idling speed If oil pressure drops below these values, stop the engine and determine the cause. 34 All information subject to change without notice. Copyright © 2014 DETROIT DIESEL CORPORATION DDC-SVC-MAN-0175