DD Platform EuroIV Operators Manual Oil analysis may be used to determine whether this interval should be shortened, but it should not be used to lengthen the interval. The use of fuels with sulfur content above 0.05 mass percent will require a shortening of drain intervals and/or the use of a higher TBN oil. Disposal of Waste Oil Used lubricating oil and filters require disposal in an environmentally responsible manner, according to federal (EPA) and/or state recommendations. The disposal of waste oil may be best addressed by the engine oil supplier, who may accept responsibility for proper disposal of this material as part of the business of providing lubricant.
How to Replace the Lubricating Oil and Oil Filter The oil filter is an integral part of the lubrication system. Proper filter selection and maintenance are important to satisfactory engine performance and service life. The filter should be used to maintain a clean system, not to clean up a contaminated system. The maintenance intervals for the appropriate duty cycle are listed in tables in this manual. Change the oil and replace the lubricating oil filter as follows: NOTE: If the used oil was contaminated by fuel or coolant, it may be necessary to take the vehicle to a certified Detroit Service Center.
The Service Center may drain the oil and then remove the oil pan, oil pump, and oil pump intake manifold to drain the remaining oil held back by the backflow valve. It is important to remove all contaminated oil from the engine. NOTE: Change the engine oil only when the engine oil temperature is approximately 60°C (140°F). Changing cold oil will result in extended drain times. WARNING: PERSONAL INJURY To avoid injury, never remove any engine component while the engine is running. 1. Place the transmission in neutral, and set the parking brake. NOTICE: Use care to prevent foreign objects from entering the filter housing. 2. Clean outside of the oil filter housing. 3.
Using a 36-mm socket, unscrew the oil filter cap and filter and allow the oil to drain into the housing. After draining is complete, remove the assembly from the housing. All information subject to change without notice. 79 DDC-SVC-MAN-0175 Copyright © 2014 DETROIT DIESEL CORPORATION