DD Platform EuroIV Operators Manual NOTICE: Do not add oil if the oil reading is between the crosshatch area on the dipstick. There are approximately 5.0 L (5.2 qt) from the fill mark to the full mark. Overfilling the oil pan can cause engine damage. NOTE: If the engine operating temperature is below 60°C (140°F), the engine must be on a level surface and then shut down for 60 minutes for an accurate oil level reading. Otherwise, the engine must be brought up to an operating temperature of 60°C (140°F), parked on a level surface and then shut down for five minutes for an accurate oil level reading. 13. Check the filter housing for signs of leakage. 14. Stop the engine.
Check the oil level again per the following guidelines. If necessary, add oil no more than 5.0 L (5.2 qt) at a time up to the maximum fill level on the oil dipstick. How to Select Diesel Fuel All EuroIV DD engines are designed to operate on Low Sulfur Diesel fuel. Quality NOTICE: Use only Low Sulfur Diesel (LSD) fuel (500 PPM sulfur content maximum), based on ASTM Standard D 2622 test procedure. All information subject to change without notice. 81 DDC-SVC-MAN-0175 Copyright © 2014 DETROIT DIESEL CORPORATION