DD Platform EuroIV Operators Manual 4. Discard the water coalescer/final filter. 5. Inspect inside the housing for any large debris, clean housing as needed. 6. Discard water coalescer/final filter cap seal ring. Installation of the Coalescer/Final Filter - Two Filter System Install the water coalescer/final filter as follows: NOTE: If a fuel filter service is being performed, replace all other fuel filters before priming the fuel system. 1. Install a new seal ring on to water coalescer/final filter cap. 2. Snap a new water coalescer/final filter into the water coalescer/final filter cap. 3.
Apply a light coat of Parker super O-lube or petroleum-based lithium grease to the water coalescer/final filter cap seal ring and drain back plug seal ring (C).Apply a heavy coat of Parker super O-lube or petroleum-based lithium grease to the upper (A) and lower seals (B) on the water coalescer/final filter. All information subject to change without notice. 87 DDC-SVC-MAN-0175 Copyright © 2014 DETROIT DIESEL CORPORATION