ESS00083 TUNING ESS00084 CARBURETOR TUNING The carburetors are set at the factory to run at temperatures of 0 C –20 C (32 F F) at sea level. If the machine is to be operated un- der conditions other than those specified above, the carburetors must be properly ad- justed. Special care should be taken in carbure- tor setting so that the pistons will not be dam- aged or will not seize. CAUTION: Engine oil is mixed with fuel just before the fuel enters the carburetors. During initial fuel flow to the carburetors, it is not always possible to supply the optimum fuel/oil mix- ture depending on the throttle opening.
Therefore, after the carburetors have been tuned or maintained, or after the float cham- bers are removed for cleaning or jet replace- ment, be sure to idle the engine for about three minutes in order to avoid engine trouble. CAUTION: Before performing the carburetor tuning, make sure that the following items are set to specification. Engine idle speed Throttle cable freeplay Carburetor synchronization Starter cable freeplay Oil pump cable freeplay ESS00085 Carburetor tuning data 1.
Standard specifications 2-31 CARBURETOR TUNING INSP ADJ A Type B38-34/1 B Manufacturer MIKUNI C Main jet (M.J.) #141.3 D Pilot jet (P.J.) #90 E Pilot screw (P.S.) 1-1/4 turn out F Float height 12 16 mm (0.47 0.63 in) G Idle speed 1,200 ± 100 r/min