ESS00091 Troubleshooting 2-36 CARBURETOR TUNING INSP ADJ Trouble Diagnosis Adjustment Hard starting Insufficient fuel Add gasoline. Excessive use of the starter or choke Return the starter lever to its seated position so that the starter valve is fully closed. Fuel passage is clogged or frozen Check and, if necessary, clean the fuel tank air vent, the fuel filter and all of the fuel passages. Check and, if necessary, clean the carburetor air vents, fuel passages and the float valve. Clean the float chamber of any ice or water. Overflow Adjust the fuel level. Poor idling:
Poor performance at low speeds Poor acceleration Slow response to throttle Engine tends to stall Improper idling speed adjustment Adjust the engine idle speed. Refer to “Low speed tuning”. Damaged pilot screw Replace the pilot screw. Clogged bypass hole Clean the bypass hole. Clogged or loose pilot jet Remove the pilot jet, clean it with compressed air and then install it. Make sure that the pilot jet is fully tightened. Air leaking into the carburetor joint Retighten the clamp screws on the carburetor joints. Defective starter valve seat Clean or replace the starter valve seat. Overflow Adjust the fuel level. Poor performance at mid-range speeds:
Momentary slow response to the throttle Poor acceleration Clogged or loose pilot jet Remove the pilot jet, clean it with compressed air, and then install it. Make sure that the pilot jet is fully tightened. Lean mixture Overhaul the carburetors. Poor performance at normal speeds: Excessive fuel consumption Poor acceleration Clogged air vent Remove the air vent hose and clean it. Clogged or loose main jet Remove the main jet, clean it with compressed air, and then install it. Make sure that the main jet is fully tightened. Overflow Check and, if necessary, clean the float and float valve.