ESS00180 INSTALLATION 1. Hook the starter spring around the post in the starter case. Carefully wind the spring coun- terclockwise, and fit the spring into the case. NOTE: After installing the spring thoroughly apply low- temperature grease. 2. Pass the starter rope end into the sheave drum, and knot the rope end. Then fit the knot into the cutout in the sheave drum. 3. Wind: Starter rope (2 turns counterclockwise) (to sheave drum) 4. Install: Sheave drum (into starter case) NOTE: Be sure the inner hook on the starter spring hooks around the post on the sheave drum. 5. Apply: Grease (lightly) (to pivot point of the drive pawl) 6. Install: Drive pawl 1 Return spring 2 NOTE:
Hook the return spring end to the drive pawl 1 . Then, hook other end of the return spring to the post 3 on the sheave drum. 5-29 RECOIL STARTER ENG Low-temperature grease