Yamaha Motor Co., Ltd. VK540E — Yamaha Motor Co., Ltd. VK540E User Manual

STARTER MOTOR Inspection 1. Inspect: Commutator (outer surface) Dirty Clean with #600 grit sandpaper 1 . Hold the armature in a vise 2 and copper or aluminium plate 3 . CAUTION: Lightly grip the armature with a vise. 2. Measure: Commutator (diameter) Measure the diameter a of the commutator at points where the brush comes in contact. Out of specification Replace. 3. Measure: Mica 1 (insulation depth) (between commutator segments) Out of specification Scrape mica to proper limits. Use a hacksaw blade 2 that is ground to fit. 4. Measure: Armature coil resistance (insulation/continuity) Defect(s) Replace starter motor. Inspecting steps:

Connect the pocket tester for the continuity check 1 and the insulation check 2 . Measure the armature coil resistances. Armature coil resistance: Continuity check 1 : 0.016 Ω ± 10% at 20 C (68 F) Insulation check 2 : More than 100 k Ω at 20 C (68 F) If the resistance is incorrect, replace the starter motor. 7-22 ELECTRICAL STARTING SYSTEM ELEC Commutator wear limit a : 27.0 mm (1.06 in) Mica undercut limit 3 : 0.6 mm (0.024 in)