ESS00029 PERIODIC INSPECTIONS AND ADJUSTMENTS ESS00030 INTRODUCTION This chapter includes all information necessary to perform recommended inspections and adjust- ments. These preventive maintenance procedures, if followed, will ensure more reliable machine operation and a longer service life. In addition, the need for costly overhaul work will be greatly reduced. This information applies to machines already in service as well as new machines that are being prepared for sale. All service technicians should be familiar with this entire chapter.
ESS00031 PERIODIC MAINTENANCE TABLE 2-1 INTRODUCTION/PERIODIC MAINTENANCE TABLE INSP ADJ Item Remarks Pre- operation check (Daily) Initial 1 month or 800 km (500 mi) (40 hr) Every Seasonally or 3,200 km (2,000 mi) (160 hr) Spark plug Check condition adjust the gap and clean. Replace if necessary. Engine oil Check oil level. Air bleed the oil pump if necessary. Oil filter Check condition. Replace if necessary. Fuel Check fuel level. Fuel filter Check condition. Replace if necessary. Fuel line Check fuel hose for cracks or damage. Replace if necessary. Oil line Check oil hose for cracks or damage. Replace if necessary. Carburetor Check throttle lever operation.
Adjust the jets. Whenever operating condition (elevation/temperature) is changed. Fan belt Check wear and damage. Replace if necessary. Adjust fan belt if necessary. Manual starter Check operation and rope damage. Replace if necessary. Engine stop switch Check operation. Repair if necessary. Throttle override system Check operation. Repair if necessary. Throttle lever Check operation. Repair if necessary. Exhaust system Check for leakage. Retighten or replace gasket if necessary. Decarbonization More frequently if necessary. Drive V-belt guard Check cracks, bends or damage. Replace if necessary. Drive V-belt Check wear and damage. Replace if necessary.