TIGHTENING TORQUE 8-13 MAINTENANCE SPECIFICATIONS SPEC Part to be tightened Tightening torque Remarks Nm mkg ftlb Crankcase (First) (Final) Front engine mount bolt (left) Front engine mount bolt (right) Rear engine mount bolt Cylinder head (First) (Final) Cylinder Exhaust pipe and cylinder Carburetor joint and cylinder Reed valve Spark plug Cooling fan driven pulley nut CDI magneto and crankshaft Recoil starter case Recoil starter drive plate Recoil starter pulley Throttle cable locknut Carburetor Main nozzle Main jet Pilot jet Valve seat Float chamber cover Starter plunger cap Primary sheave (First) (Final) Roller (primary sheave) Weight (primary sheave) Primary sheave cap Spider Secondary sheave Secondary shaft (jackshaft) bearing housing Shift rod and shift link lever Drive chain housing and frame Drive chain housing Drive chain housing oil drain bolt Driven sprocket Brake caliper and drive chain housing Brake caliper end cover Brake caliper stationary cover Speedometer gear and frame Front axle Steering bearing holder (nut) 13 21 103 53 53 13 25 25 30 14 1 20 43 85 10 10 23 0.8 3 2 0.8 5 9 3.5 120 60 6 6 14 200 60 21 10 21 10 10 100 48 2 9 21 85 19 1.3 2.1 10.3 5.3 5.3 1.3 2.5 2.5 3.0 1.4 0.1 2.0 4.3 8.5 1.0 1.0 2.3 0.08 0.3 0.2 0.08 0.5 0.9 0.35 12.0 6.0 0.6 0.6 1.4 20 6.0 2.1 1.0 2.1 1.0 1.0 10 4.8 0.2 0.9 2.1 8.5 1.9 9.4 15 74 38 38 9.4 18 18 22 10 0.7 14 31 61 7.2 7.2 17 0.58 2.2 1.4 0.58 3.6 6.5 2.53 85 43 4.3 4.3 10 145 43 15 7.2 15 7.2 7.2 72 34.7 1.4 6.5 15 61 14 Tighten the bolts in two stages.
Tighten the bolts in two stages. Apply LOCTITE Tighten the bolts in two stages. See NOTE. Left-hand thread