a. Start the engine and rotate the track once or twice. Stop the engine. b. Check the track alignment with the slide run- ner 3 . If the alignment is incorrect, turn the left and right adjusters to adjust. 8 Slide runner 9 Track 10 Track metal 11 Gap 12 Forward c. Adjust the track deflection until the specified amount is obtained. Track deflection More than specified Less than specified CAUTION: The adjusters should be turned an equal amount. Recheck the alignment and deflection. If nec- essary, repeat steps (a) to (c) until the speci- fied amount is obtained. Tighten the rear axle nut. ESS00070 SLIDE RUNNER INSPECTION 1. Inspect: Slide runner 1 Cracks/damage/wear Replace the slide runner.
2. Measure: Slide runner thickness a Out of specificaiton Replace the slide run- ner. 2-22 TRACK TENSION ADJUSTMENT/ SLIDE RUNNER INSPECTION INSP ADJ Track alignment 6 Shifted to right 7 Shifted to left 4 Left adjuster Turn out Turn in 5 Right adjuster Turn in Turn out 4 Left adjuster Turn in Turn out 5 Right adjuster Turn in Turn out Nut (rear axle): 80 Nm (8.0 mkg, 58 ftlb) Slide runner wear limit a : 10 mm (0.39 in)