ESS00079 ELECTRICAL ESS00080 HEADLIGHT BEAM ADJUSTMENT 1. Place the machine on a level surface. 2. Measure the distance from the floor to the center of the headlight and place a mark on the wall equal to distance H from the floor. 3. Place the machine from the wall at a distance D indicated by the chart below. 4. With a person sitting on the machine, apply the parking brake, start the engine and let it idle. 5. Turn the headlight to high beam and check the headlight projection height on the wall. The projection should be at the parallel mark on the wall H to 1/2 down S from the mark. If not, adjust the headlight angle. D : Distance S : Set range 6. Adjust:
Headlight beam (vertically) Vertical adjustment Higher Turn the adjusting screw 1 coun- terclockwise. Lower Turn the adjusting screw 1 clock- wise. 7. Adjust: Headlight beam (horizontally) Horizontal adjustment Right Turn the adjusting screw 1 coun- terclockwise. Left Turn the adjusting screw 1 clock- wise. 2-27 HEADLIGHT BEAM ADJUSTMENT INSP ADJ D 3.0 m (10 ft) 7.6 m (25 ft) S 26 mm (1.0 in) 66 mm (2.6 in)