Test 39 Throttle lever signal Throttle lever position Min. 0 % Max. 100 % Measure voltage at control box across terminal 14 and terminal 15 Setpoints: Idle speed setting: 1.92 V Full load setting: 9.6 V – Check lines – Check plug connections – Check throttle lever control system – Fit new control box Simulation of idle switch in control box Throttle lever position Min. 0 % Max. 100 % Measure voltage at socket box across pin 39 (+) and pin 13 (–) alternative: Measure voltage at control box across terminal 17 and terminal 10 At control box check green LED “ld. Sp. Sw” Setpoints: Idle speed setting: 4.75–5.25 V, Green LED: off Full load setting: 0.0–2.0 V, Green LED:
on – Check lines – Check plug connections – Fit new control box