. OPERATION MACHINE OPERATIONS AND CONTROLS Hydraulic Equipment Warm Up WARNING Before carrying out the warm-up operation for the hydraulic equipment, 3 - 134 turn the swing lock switch ON, ch eck on the monitor that the swing l ock monitor lights warm-up oper When warm u up to show that the swing lock is actuated, then start the ation. p the hydraulic equipment, check that there is no person or obstacle in operation. the surrounding area, then sound the horn and start the Carry out the warm-up operation for the hydraulic equipment until the hydraulic oil t emperature monito r displays the corr ect temperature .
( When the hydr aulic oil temperatur e is low, the low t emperature display shown on the r ight is given. (A) Display wh en temperature is c orrect: Monitor bac kground (C) is b lue (B) Display wh en temperature is lo w: Monitor backgr ound (C) is white) The warm-up operation for the h ydraulic equipme nt is necessary not only for the c ircuit between the pump and cylinder s and between the pump and mo tor, but also for all the control circuit s. Do not carry out the operation just for one cylinde r or motor, or the o peration just in one direction. Ca rry out the operat ion in both direc tions for the w ork equipment (b equipped). oom, arm, bucket), swing, travel, and attachment (if 1.
Check tha t engine coolant temperature. when temperature is correct: Mo is blue r background (C) e tional warm up of e until engine coolant temperature monitor (1) e correct temperature. of the procedure, see "Engine Warm Up (PAGE