. OPERATION TROUBLES AND ACTIONS TROUBLES AND ACTIONS out, then pump it in REMARK It is not necessary to remove the plug at the top of the fuel pre-filter and fuel main filter. 2. Push in the knob of feed pump (1) and tighten it. 3 - 188 RUNNING OU When starting the engine again after run ning out of fu el, fill with fuel, then bleed the air from the fuel system before starting the engin Procedure for Ble 1. Loosen the kn he movement become 3. Turn the key i n the starting switch to the START position and start the engin When doing t for more than at least 2 min maximum of 4 e. his, do not crank the st arting motor continuously 20 seconds.
If the engi ne does not start, wait for utes, then try again. Perform this operation a times. PHENOMENA THAT ARE NOT FAILURES Note that the following phenomena are not failures: Note that the follo wing phenomena are n When the arm c ontrol lever is operated to the IN po sition and the work equipmen t is lowered under no l oad from a h igh position, the arm speed will drop momentarily when the arm is more or cal position. less at the verti When the buck et control lever is opera ted to the C URL position and the work e position, the b quipment is lowered u nder no load from a h igh ucket speed will drop momentari ly when the ition.
the bucket teeth ar e more or less at the h orizontal pos The bucket or arm will fluctuate by itself during heavy-duty ons. digging operati When starting or stopping the swing, n oise will be emitted fr om the When going do wn a steep slope at lo w speed, a n oise will b e emitted from the travel mot