. MAINTENANCE MAINTENANCE INFORMATION 4 - 3 Dusty Jobsite as follows: When working at dusty worksites, do Clean the radiator fins and other pa rts of the heat exchange equipment more frequently, and take care not to let the fins become clogged. tly. cially the starting motor and alternator, to avoid accumulation of dust. Replace the fuel filter more frequen Clean electrical components, espe cially the starting motor and alternator, to avoid accumulation of du When checking and replacing the o il or filters, move the machine to a place where there i s no dust and take care to prevent dust from entering the sy stem.
Avoid Mixing Lubricants If a different brand or grade of oil has to be added, drain the old oil and replace all the oil with the new brand or grade of oil. Never mix different brand or gra de of oil. Locking the Inspection Covers Lock inspection cover securely into position with the lock bar. If inspection or maintenance is performed with inspection cover not locked in position , there is a danger that it may be suddenly blow shut by t he wind a nd cause injury to the worker. Hydraulic System - Air Bleeding When hydraulic equipment has been r epaired or replaced, or the hydraulic piping has been removed and installed again, the air must be bled from the cir cuit.
For details, see "BLEEDING AIR FROM HYDRAULI C SYSTE M (PAGE 4-44)". Hydraulic Hose Installation When removing parts at locations replace with new parts. When doing this, be careful not to f where there are O-rings or gasket seals, clean the mounting surface, and orget to assemble the O-rings and gaskets. When installing the hoses, do not t wist them or bend them sharply. If they are installed so, t heir servi ce life will be shortened extremely and they m ay be damaged. Checks After Inspection and Maintena nce Works If you forget to perform the checks afte r inspection and maintenance, unexpected problems may occur, and this may lead to serious injury or property dam age.
Always do the following: stopped) nance points been forgotten? ance items been performed correctly? opped inside the machine? It is particularly dangerous if parts are dropped ht in the lever linkage mechanism. t or oil? Have all nuts and bolts been tightened? operating the engine, see "TWO WORKERS FOR MAINTENANCE WHEN -36)" and pay careful attention to safety. nce items working properly? l when the engine speed is raised?
Checks after operation (with engine Have any inspection and mainte Have all inspection and mainten Have any tools or parts been dr inside the machine and get caug Are there any leakage of coolan Checks when operating engine For details of the checks when ENGINE IS RUNNING (PAGE 2 Are the inspection and maintena Is there any leakage of fuel or oi Close engine hood securely When closing the engine hood after in spection or maintenance, make sure that the catch i s securely loc ked. Hold the grip of the engine hood and raise it slightly. If it does not open, the catch is locked. , there is danger that the engine hood may open. If the engine hood catch is not locked