Komatsu — ELECTRIC SYSTEM MAINTENANCE

. MAINTENANCE OUTLINE OF SERVICE OIL SAMPLING Sampling interval 250 hours: Engine 500 hours: Other components 4 - 7 25 50 Precautions when sampling Make sure that the oil is well mixed bef Perform sampling at regular fixed interv Do not perform sampling on rainy or wi For fu rther details of KOWA, please contact y STORING OIL AND FUEL other impurities from getting in. Keep indoors to prevent any water, dirt, or When keeping drum cans for a long period, put the drum on its side so that the filler port of the drum s is at the side to prevent moisture from being sucked in. If d rums have to be stored outside, cover t hem with a waterproof sheet or take other measures to protect them.

To prevent any change in quality during lon g-term storage, be sure to use in the order of first in - fir st out (use the oldest oil or fuel first). FILTERS Filters are extremely important safety par ts. They prevent impurities in the fuel and air circuits from entering s. see the Operation and Maintenance Manual. important equipment and causing problem Replace all filters periodically. For details, However, when working in severe conditio ns, replace the filters at shorter intervals according to t he oil and fuel (sulfur content) being used. ) and use them again. Always replace with new filters. Never try to clean the filters (cartridge type ) and use them again.

Always replace with new filters. When replacing oil filters, check if any meta l particles are attached to the old filter. If any metal parti cles are found, contact your Komatsu distributor. before they are to be used. Do not open packs of spare filters until just Always use Komatsu genuine filters. ELECTRIC SYSTEM MAINTENANCE It i s extremely dangerous if the electrical eq uipment becomes wet or the covering of the wiring is d amaged. This wil l cause an electrical short circuit and m ay lead to malfunction of the machine. Do not wash th e inside of the operator's cab with water. When washin components.

g the machine, be careful not to let water get into the electrical Service relating to the electric system is ch ecking fan belt tension, checking damage or wear to t he fan belt and checking battery fluid level. r than those specified by Komatsu. Never install any electric components othe External electro-magnetic interference ma y cause malfunction of the control system controller, b efore installing a r adio receiver or other wireless equipme nt, contact your Komatsu distributor. ean the electric system to prevent corrosion. ect it to the special power source connector. to the fuse, starting switch, or battery relay.

When working at the seashore, carefully cl When installing electrical equipment, conn Do not connect the optional power source