Komatsu — CLEAN INSIDE OF COOLING SYSTEM

. MAINTENANCE MAINTENANCE PROCEDURE corrosion resistor (only for machines stopper, then remove it. 4 - 27 1. Stop the machine on level g 2. Tighten valve (1) of the corr equipped with a corrosion re 3. Check that the cooling wat er temperature has gone down 4. enough to make it possible to touch the radiator cap surface by hand, then turn radiator ca stopper to release the press Following this, push radiator p (2) slowly until it contacts the ure. cap (2), turn it until it contacts the 5. Remove the undercover, th en set the container under drain t mixture. valve (3) to catch the coolan Open drain valve (3) at the b ottom of the radiator and drain the coolant. 6.

After draining the coolant, clo water. When the radiator is fu se drain valve (3), and fill with city ll, start the engine and run at low idling to raise the temperatu continue to run for approx. 1 re to at least 90°C (194°F), then 0 minutes. ain valve (3) to drain the water. n the radiator with detergent. ow the instruction of detergent. stor, and open valve (1).(Only osion resistor) f the corrosion resistor cartridge, ION RESISTOR CARTRIDGE freeze until it overflows from the 7. 8. Stop the engine and open dr After draining the water, clea For the cleaning method, foll 9. Close drain valve (3). Replace the corrosion resi 10.

machines equipped with corr For details of replacement o see "REPLACE CORROS (PAGE 4-71)". Install the undercover. Add coolant mixed with anti water filler. 11. 12. Decide the proportions of anti freeze and water according to the table for the mixing rate of w ater and antifreeze. for 5 minutes to remove the air igh idling for 5 minutes. (Leave en doing this.) 13. Run the engine at low idling from the water, then run at h radiator cap (2) removed wh