Komatsu — REPLACE BUCKET TEETH (VERTICAL PIN TYPE)

. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE 4 - 34 8. Fit tooth (1) to adap ter (4), and confirm that when th e pointe r is pressed strongly, t teeth (1) is at the s pin of the adapter ( If the rear face of t the rear face of the in. If this happens, the from fitting comple remove the obstru adapter (4), knock he rear face of the hole for the pin of the ame level as the rear face of the hole for the 4). he pin hole of tooth (1) p rotrude s in fron t of pin hole of adapter (4), d o not kn ock the pin re is something (C) preventing t he tooth (1) tely in adapter (4), locat e the p roblem a nd ction. When tooth (1) fits completely in in lock pin (2). mpletely 9.

Insert lock pin (2) in the pin hole in the tooth (1), an d knock i t in so that the top surf surface of tooth (1) ace of lock pin (2) is the s ame h eight as the . ucket tooth, always check the following. 10. After replacing a b ucket tooth, always chec k the fo llowing. 1) After the lock check that it is 2) Lightly hit lock was hit in. 3) Lightly hit the ti hit its sides fro 4) Confirm that ru shown in the fi pin (2) has been knocked in completely, secured by the teeth (1) and su rface. pin (2) in the reverse direction fr om whic h it p of the teeth (1) from above and below, a nd m right and left. bber pin lock (3) and loc k pin (2 ) are set as gure.

REMARK If the tooth is turned, t he wear will become uniform. This will extend the service life of the tooth and reduce the ent. If frequency of replacem When replacing the too th, replace the rubber pin lock an d lock p in with new parts a t the same time. This will preven the tooth from falling o ut. the servic