. MAINTENANCE MAINTENANCE PROCEDURE 4 - 45 NOTICE If the air is no t bled from the s wing motor, the motor bea rings ma y be d When replaci ng the travel mot or safety valve, p lease con tact your Koma tsu distributor to have it r eplaced and to have the air bled. 5. Bleeding a ir from travel m (Bleed the air only when the oil inside the travel motor case ha 1) Run the engine at low idling, loosen air bleeder (4), and tighten it when oil flows out.
(Bleed the air only when t he oil inside th e travel m otor case ha 1) Run th e engine at lo tighten it when oil flow 2) Run th e engine at low idle and swin g the wor 90° to bring it to the si de of the track 3) Jack u p the machine until the track slightly the gro und.Rotate the track under n o load for Repea t this procedure on both the le ft and rig ht sides, rotate t he track equall y both forward and in re verse. 6. Bleeding a ir from attachm ent (when installed) I f a breake r or other attach ment has bee n installed , run th e engi ne at low idle and opera te the attachment peda repeatedly (approx. 10 tim es) until the ai r has be en bled from t he attachment circuit.
NOTICE If the method of bleeding the air from the attachment its elf is specified by the manufacturer, ble ed the air according to the specified pro cedure. After complet ing the air bleedi ng operation, st op the eng ine, and leave t he machine for 5 minutes before starting operations. This will remo ve the air bubble s in the oil insid e the hydr aulic cylinders. Chec k that th ere is no leakage of oil and wipe off any oil that has been s After complet ing the air bleedi ng operation, in spect the o il level, and if t he oil level is low, add oil.