. MAINTENANCE MAINTENANCE PROCEDURE CLEAN AND INSPECT RADIATOR FINS, OIL COOLER FINS, AFTERCOOLER FINS, FUEL COOLER FINS, AND AIR CONDITIONER CONDENSER FINS (only machines equipped with air conditioner) WARNING 1. Open engine hood (1). 4 - 58 If compressed air, high-pressure w ater, or steam hits your body directly or dirt is sent flying by the co mpressed air, high-pressure water, or steam, there is danger of personal injury. Always wear protective glasses, dust mask, and other protective equipment. NOTICE When using compressed air for cle aning, blow it keeping some distance to avoid damaging the fins. D amage on the fins can cause water leakage and overheating.
In a dusty job site, check the fins ever y day, regardless of the maint enance interval. 2. Loosen screw (3) and pull up net (2). an it. urfaces of oil cooler fins (4), radiator 3. After pulling up net (2), cle (Install it again in Step 7.) 4. Check the front and rear s fins (5), aftercooler fins (6) and fuel cooler fins (8). If t to the fins, blow the dirt off Steam or water may be However, when carryin (high-pressure machine equipment (radiator, oil c conditioner condenser), m machine when carrying o (high-pressure machine w there is danger that the i equipment may be deform and breakage. 5. Check the rubber hose.
R , Air conditioner condenser fins (7), here is any mud, dirt, or leaves stuck with compressed air. used instead of compressed air. g out powerful steam cleaning wash) of the heat exchange ooler, aftercooler, fuel cooler, air air aintain sufficient distance from the ut the operation. If steam cleaning ash) is carried out at close range, the nternal fins of the heat exchange ed, and this will cause early clogging eplace with a new one if the hose is found to have cracks or to check the hose clamps for be hardened by aging. In addition, looseness.