. MAINTENANCE MAINTENANCE PROCEDURE CHANGE OIL IN HYDRAULIC TANK WARNING may cause burns. Wait for the 4 - 83 EVERY 5000 HOURS MAI NTENANCE Carry out the periodic maintena nce work of every 100, 250, 500 and 1000 hours o f operation at the sa The parts and oil are at high te mperature immediately after the engine is stopped, a tarting the work. temperature to go down before s When removing the oil filler cap, turn it slowly to release the internal pressure, then remo NOTICE If the machine is equipped with a h ydraulic breaker, the hydraulic oil will deteriorate much faster than during normal bucket If operations. For details, see "MA maintenance.
INTENANCE INTERVAL FOR HYDRAULIC BREAKER (PAGE 4-17)" when carrying out Refill capacity: 132 liters (34. Prepare a handle (for the soc 1. 2. 3. 1. Swing so that the drain plug is in the middle between the 2. Retract the arm and bucket c put the teeth in contact with 3. Set the lock lever to the LO 4. Remove the cap of oil filler port (F) at the top of the hydraulic r the drain plug under the machine . Remove drain plug (P) and drain -ring installed to plug (P) is not replace the O-ring. After draining . torque is 68.6 ± 9.81 Nm (7 ± 1 n yourself when you remove drain tank. 5. Set a container directly unde to catch the oil that is drained the oil. Check that the O damaged.
If it is damaged, the oil, tighten drain plug (P) The specified tightening kgm, 50.6 ± 7.2 lbft) Take care not to get oil o plug (P). to catch the oil that is drained the oil. Check that the O damaged. If it is damaged, the oil, tighten drain plug (P) The specified tightening 6. Fill with the specified amoun t of oil through oil filler port (F). Check that the oil level is between the H - L lines on the sight gauge. oil, see "RECOMMENDED FUEL, COOLANT, AND LUBRICANT (PAGE 4-9)". For details of the suitable oil, see "RECOMMENDED FUEL, COOLANT, A ND LUBRICANT (PA For details of the method 3-115)".
For details of the method of checking the oil level, see "Check Oil Level in Hydraulic Tank, Add Oil (PAGE ulic circuit. 7. Bleed the air from the hydra For details of the method of b leeding the air from the hydraulic circuit, see "BLEE DING AIR FROM HY DRAULIC SYSTEM (PAGE 4-44)".