Troubleshooting OPERATION Other trouble Engine 0. ( ): Always contact your Komatsu distributor when dealing with these items. In cases of abnormalities or causes which are not listed below, please contact your Komatsu distributor for repairs. 3-106 Problem Main causes Remedy Engine oil pressure caution pilot lamp lights up •Low engine oil pan oil level (suck- ing in air) •Clogged oil filter cartridge •Defective tightening of oil pipe joint, oil leakage from damaged part •Defective monitor •Add oil to specified level, see "Check before starting on page 4- 35". •Replace cartridge, see "Every 500 hours service on page 4-44".
(•Check, repair) (•Replace) Steam is emitted from top part of radiator (pressure valve) Water temperature gauge is in red range Coolant temperature monitor lights up •Low cooling water level •Defective fan pump motor •Dirt or scale accumulated in cool- ing system •Clogged radiator fin or damaged fin •Defective thermostat •Loose radiator filler cap (high alti- tude operation) •Defective monitor •Check, add cooling water, repair, see "When required on page 4- 18". (•Check, repair) •Change cooling water, clean inside of cooling system, see "When required on page 4-18". •Clean or repair, see "When required on page 4-18".
(•Replace thermostat) •Tighten cap or replace packing (•Replace) Water temperature gauge is in white range on left •Defective thermostat •Defective monitor (•Replace thermostat) (•Replace) Engine does not start when start- ing motor is turned •Lack of fuel •Air in fuel system •No fuel in fuel filter •Defective injection pump or noz- zle •Starting motor cranks engine too slowly •Starting motor does not turn •Preheating pilot lamp does not light up •Defective valve clearance (Defec- tive compression) •Add fuel, see "Check before starting on page 4-35". •Repair place where air is sucked in •Fuel filter with fuel. See "Every 500 hours service on page 4-44".
(•Replace pump or nozzle) •See "Electrical system on page 3-103". •See "Electrical system on page 3-103". •See "Electrical system on page 3-103". (•Adjust valve clearance) Exhaust gas is white or blue •Too much oil in oil pan •Improper fuel •Add oil to specified level, see "Check before starting on page 4- 35". •Change to specified fuel