OPERATION Explanation of components Machine monitor E00: If travel speed overrun is displayed, ease the accelerator pedal back to reduce speed. REMARK “E00“ is displayed on the character display, and then “OVERRUN PREVENTION“ and “E00“ are displayed in turn for 3 seconds each. Failure code display 0. If an action code is displayed on the character display, check the failure code according to the failure code display method given below. When contacting your Komatsu distributor to request repairs, please inform your distributor of the failure code. Method of displaying failure code 1.
If an action code is displayed on the character display of display portion (4), press the top (>) of monitor panel mode selector switch 2 (A). The action code will change to the failure code. The failure code is displayed with the first 6 digits on the left side of the character display. The code displayed after the space on the right side of the failure code indicates the controller that detected the failure code. The failure code and the component causing the failure are displayed on the character display in turn for 3 sec- onds each. 2. Press the top (>) of monitor panel mode selector switch 2 (A) again.
If the condition is normal, the service meter is displayed for several seconds, then the display returns to the action code. If more than one failure has occurred at the same time, the next failure code is displayed. Filter, oil replacement time display 0. After completion of the system check and when the starting switch is in the ON position, if any filter or oil item is approach- ing the replacement time, this display (5) shows the item for approx. 30 seconds. When this happens, the maintenance caution lamp also flashes or lights up. After replacing the filter or changing the oil, reset the time for replacement. For details, see “Reset method for filter, oil replacement time on page 3-26“.
3-11 Top right code Controller detecting failure code MON Machine monitor HST HST controller