PERIODIC SERVICE 84 EVERY 200 HOURS B Checking Oil Cooler Line 1. Check to see that all lines and hose clamps are tight and not damaged. 2. If hoses and clamps are found worn or damaged, replace or repair them at once. (A) Wheel - to - wheel distance at rear (B) Wheel - to - wheel distance at front (C) "FRONT" C Adjusting procedures 1. Detach the snap ring. 2. Loosen the tie-rod nut. 3. Turn the tie-rod joint to adjust the rod length until the proper toe-in measurement is obtained. 4. Retighten the tie-rod nut. 5. Attach the snap ring of the tie-rod joint. (1) Oil cooler (2) Oil cooler line B Adjusting Toe-in 1. Park tractor on a flat place. 2.
Turn steering wheel so front wheels are in the straight ahead position. 3. Lower the implement, lock the park brake and stop the engine. 4. Measure distance between tire beads at front of tire, at hub height. 5. Measure distance between tire beads at rear of tire, at hub height. 6. Front distance should be shorter than rear distance. If not, adjust tie rod length. (1) Snap ring (2) Tie-rod nut 167 to 196 N-m (17 to 20 kgf-m) (3) Tie-rod joint Proper toe-in 2 to 8 mm